TM 10-5410-224-14
(h) Attach lock bracket (11) and seal (12) to
(c) Replace jack support plate by securing
to personnel end panel with two screws (24) and
door with thumbscrew (10) and sleeve (13).
(i) Position tube (28) in hole in door and
washers (25).
insert square shaft of handle (2) through handle
(d) Install jack in accordance with
bracket and tube (28).
paragraph 3-3a(3).
(j) Attach handle bracket (7) to door using
(13) Removal and replacement of right cargo
three screws (4), lockwashers (5), and flat washers
door handles and lock rods (fig. 3-20). To remove
(6).
and replace door handles (2 and 7), lock rods (21)
(k) Slide four rubber washers (27) onto
and associated hardware, proceed as follows:
handle shaft.
(a) Remove spring pin (1) from handle (2)
(l) Attach center case assembly (25) to door
and remove handler and washer (3).
using four bolts (22) and washers (23).
(b) Disengage two lock rods (21) from
(m) Slide lock rods (21) into case (17) and
eccentrics on center case assembly (25) and remove
engage other ends with eccentrics on center case
lock rods.
assembly (25).
(c) Remove four bolts (22) and washers (23)
(n) Position washer (3) and handle (2) on
to detach center case assembly (25). Also remove
shaft of handle (7), align hole in handle (2) with
four rubber washers (27) and tube (28).
hole in shaft and insert pin (1).
(d) Detach handle (7) by removing three
(o) Check that operation of door handles is
screws (4), lock washers (5) and flat washers (6).
free from binding.
(e) Remove lock bracket (11) and seal (12)
by removing thumbscrew (10), and sleeve (13).
(14) Removal and replacement of step
(f) Remove four screws (14), lock washers
assembly (fig. 3-24). To remove and replace step
(15), and flat washers (16) to detach case (17),
assembly (16) on left cargo door, proceed as
shim (18), and spacer (19).
follows:
(a) Remove two screws (14) and washers
NOTE
Replace the entire assembly in accordance with the
(15) to detach each step assembly (16).
following steps.
(b) Replace each step assembly (16) by
securing to left cargo door with two screws (14)
(g) Replace case (17) with shim (18) and
and washers (15).
spacer (19) in proper position and secure with four
screws (14), lockwashers (15) and lock washers
(16).
3-39
