TM 9-4931-374-13&P
3-26. WIRING HARNESS ASSEMBLY (BENCH)--MAINTENANCE INSTRUCTIONS
THIS TASK COVERS:
a. Removal
d. Repair
b, Inspection
e. Reassembly
c. Disassembly
f. Installation
INITIAL SETUP
Test Equipment
Appendix D
Appendix E
3-74
Wire table.
Special Tools
3-46
Disassembly procedure for electrical
Basic aircraft armament repairman tool set (SC
installation.
4933-95-CL-A13)
3-46
Reassembly procedure for electrical
Fire control repair shop set (SC 4931-95-CL-A21)
installation.
Supplemental aircraft armament repairman tool set
Troubleshooting References
(SC 4933-95-CL-A14)
3-9 The power supply does not operate.
3-9 There is no electrical power at work
Materials/Parts
table outlets.
Tape (item 19, app D)
WARNING
Lug terminal (MS25036-111)
The shop set contains voltages which are
Lug terminal (MS25036-156)
dangerous if contacted. Before perform-
Wire 12011690-10
ing any maintenance on the harness assem-
Wire 12011690-11
bly, be sure the circuit breaker on the
Wire 12011690-12
power distribution panel connected to
Wire 12011690-13
power source is in OFF position and the
Wire 12011690-14
120/208V cable assembly is disconnected
Wire 12011690-16
from the shop set.
Wire 12011690-18
NOTE
Wire 12011690-20
The harness assembly is comprised of
Wire 12011690-21
eleven wires tagged numbers 12 thru 22.
Wire 12011690-22
Refer to wire table (p 3-74) for further
Wire 12011690-23
description.
References
Appendix C
3-224
