TM 9-2330-390-14&P
4-81. REAR DOLLY PIVOTING TRAY REPLACEMENT (Con’t).
1.
2.
3.
If removed, install pivoting tray upper bracket and lockout brace (see paragraph 4-98).
If removed, install data plates (see paragraph 4-105).
Install two brackets (2) on pivoting tray (1) with four flatwashers (13), shoulder screws (14), flatwashers (12),
and new locknuts (11).
4.
Apply sealing compound to jamnuts (5). Fully install jamnuts on bearing rods (6) until bottomed out. install
bearing rods on brackets (2) with flatwashers (4) and new locknuts (3). Torque locknuts to 85 lb.-ft. (115 N•m).
5.
Install pivoting tray (1) on two suspension link mounting brackets (8) with two spacers (7), bearing rods (6),
flatwashers (9), and new locknuts (10). Torque locknuts to 25-30 lb.-ft. (3441 N•m).
Follow-on Tasks:
• Install engine (see paragraph 4-115).
• Install hydraulic reservoir and redundant power fittings (see paragraph 4-111).
• Install hydraulic lines (see paragraph 4-109).
• Install battery case assembly (see paragraph 444).
• Install rear dolly full function valve and air reservoir (see paragraph 4-66).
• Install rear dolly mounting bracket and shutoff valves (see paragraph 4-68).
• Install rear dolly booster relay valve (see paragraph 4-67).
• Install rear dolly relay valve (see paragraph 4-70).
• Install rear dolly parking brake valve (see paragraph 4-69).
• Install airbrake valve (see paragraph 4-65).
• Install pivoting tray gladhands (see paragraph 4-71).
• Install rear dolly air lines (see paragraph 4-73).
• Install identification light (see paragraph 442).
• Lubricate pivoting tray bearings (see Lubrication Instructions, Chapter 3, Section I).
4-217
