TM 9-2330-390-14&P
4-82.
PIVOT AXLE BRACKET REPLACEMENT (Cont).
7.
Lower top beam (1) and rest bottom beam (7) on ground. Remove lifting device from top beam.
8.
Tighten nut (20) with wrench to seat pivot bolt (22). Loosen nut, then handtighten. Wrench tighten nut 1 to 1 ¼
flats. Install setscrew (21) in nut.
NOTE
Welded pads on axle and pivot axle bracket identify correct installation location of
lockout bracket assemblies.
9.
Coat four bolts (8) with grease. Install top lockout bracket (12), four sleeves (10), bottom lockout bracket (9)
four bolts, and nuts (13) on each end of pivot axle bracket (18) and axle assembly (11). Handtighten nuts,
then tighten with wrench 1 ¼ to 2 flats.
10.
Install eight safety pins (14) on bolts (8).
NOTE
On right side, hose assemblies are secured to both side and underside of suspension
link.
11.
Install two hydraulic hose assemblies (6) on each suspension link (2) with hose clamp (3) flatwasher (4) and
self-tapping screw (5).
RIGHT SIDE
Change 3 4-221