TM 9-2330-390-14&P
4-81. REAR DOLLY PIVOTING TRAY REPLACEMENT (Con't).
1.
Remove two locknuts (10) and flatwashers (9)
from bearing rods (6). Discard locknuts.
2.
Remove pivoting tray (1) and two spacers (7) from
suspension link mounting brackets (8).
3.
Remove two locknuts (3), flatwashers (4), and
bearing rods (6) from brackets (2). Discard lock-
nuts.
4.
5.
Remove two jamnuts (5) from bearing rods (6).
Remove four locknuts (11), flatwashers (12),
shoulder screws (14), flatwashers (13), and two
brackets (2) from pivoting tray (1). Discard lock-
nuts.
NOTE
6.
Perform steps 6 and 7 if components are damaged or if replacing pivoting tray.
Remove data plates (see paragraph 4-105).
7.
Remove pivoting tray lockout brace and upper bracket (see paragraph 4-98).
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvent’s flash point is 100°F-138°F (38°C-59°C). If you
become dizzy while using cleaning solvent, Immediately get fresh air and medical help.
If solvent contacts eyes, Immediately wash your eyes and seek medical attention.
1.
Clean all components with dry cleaning solvent and allow to dry.
2.
Inspect all components for damage. Replace damaged components.
4-216
