TM 9-2330-390-14&P
4-40. TAILLIGHT MAINTENANCE (Con't).
NOTE
All wires should be tagged before removal. Refer to paragraph 4-18 for tagging
Instructions.
3.
lf damaged, replace taillight connector plugs (15) (see paragraph 4-26).
2.
Remove three locknuts (12), cable assembly ground wire (13), three flatwashers (11), lockwashers (10),
panhead screws (6) lo&washers (7) and taillight (6) from taillight assembly housing (9). Discard locknuts and
lockwashers.
1.
Cut tie-down strap from connector plugs (14 and 15). Disconnect two taillight connector plugs (15) from cable
assembly connector plugs (14). Discard tie-down strap.
2.
Connect two talllight connector plugs (15) to cable assembly connector plugs (14). Wrap connector plugs with
new tie-down strap.
1.
Install taillight (8) on taillight assembly housing (9) with three new lockwashers (7) panhead screws (6) new
lckwashers (10), flatwashers (11), cable assembly ground wire (13) and three new locknuts (12).
Follow-on Tasks:
• Connect intervehicular cable to towing vehicle (see paragraph 2-11).
• Check operation of taillight.
4-73
