TM 9-2330-390-14&P
4-38.
MARKER CLEARANCE LIGHT MAINTENANCE.
This Task Covers:
a.
Lamp Replacement
C.
Installation
b.
Removal
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Intervehicular cable disconnected from towing
• Marker tags (Item 28, Appendix F)
vehicle (see paragraph 2-7).
• Tie-down straps
Tools/Test Equipment:
• General mechanic’s tool kit (Item 30, Appendix G)
• Four locknuts
• Four lockwashers
NOTE
• Front and rear dolly marker clearance lamps and lights are replaced the same way.
Front dolly marker clearance light is shown.
• Front marker clearance lights have amber lenses. Rear marker clearance lights have
red lenses.
Install lens housing (3) on body (1) with two
screws (4).
1.
2.
3.
4.
Install lamp (2) In socket by pressing down on
lamp and turning clockwise.
Remove lamp (2) from socket by pressing down
on lamp and turning counterclockwise.
Remove two screws (4) and lens housing (3) from
body (1).
NOTE
All wires should be tagged before removal. Refer to paragraph 4-18 for tagging
Instructions.
1.
Cut tie-down straps from connector plugs (11 and 12). Disconnect marker clearance light connector plug (11)
from cable assembly connector plug (12). Discard tie-down straps.
4-68
