TM 9-2330-390-14&P
4-42.
IDENTIFICATION LIGHT MAINTENANCE (Cant).
NOTE
All wires should be tagged before removal. Refer to paragraph 4-18 for tagging
lnstructions.
1.
2.
Disconnect identification light connector plug (5) from cable assembly connector plug (6).
Remove four locknuts (7), two ground wires (8 and 9), four flatwashers (10), lockwashers (11), panhead screws
(13), and identification light (14) from pivoting tray (4). Discard locknuts and lockwashers.
3.
If damaged, replace identification light connector plug (5) and ground wire (9) (see paragraph 4-26).
4-76