TM 9-2330-275-14&P4-90. PREPARATION OF EQUIPMENT FOR ADMINISTRATIVE STORAGE (Con’t).b. StoragePlan.(1) Store equipment so as to provide maximum protection from the elements and to provide access forInspection, maintenance, and exercising. Anticipate removal or deployment problems and take suitable precautions.(2) Take Into Consideration environmental conditions such as extreme heat or cold high humidity;blowing sand, dust, or loose debris: soft ground; rind: heavy snows: or any combination thereof, and take adequateprecautions.(3) Establish a fire plan and provide for adequate firefighting equipment and personnel.c. MaintenanceServicesandInspection.(1) Maintenance Services Prior to storage, perform the next scheduled organizational PMCS.(2) Inspection. Inspect and equipment prior to storage. Do not place equipment in storagein a nonmission-capable condition.d. AuxilI ary Equipment end Basic Issue items.(1) Process auxiliary equipment and basic Issue Items simultaneousIy with the major item to which theyare assigned.(2) If possible, store auxiliary equipment and basic Issue Items with the major Item.(3) If stored apart from the major Item, mark auxiliary equipment and basic issue items with tagsindicating the major Item, its registration or serial number and location, and store in protective type closures. Inaddition, place a tag or list Indicating the location of the removed Items in a conspicuous place on the major Item.e. CorrectionofShortcomingsendDeficiencies.Connect all shortcomings and deficiencies prior tostorage, or obtain a deferment from the approving authority.t.Lubrication. Lubricate equipment In accordance with Instructions in chapter 3, section 1.g. GeneralCleaning,Painting,endPreservation.CAUTIONDo not direct water or steam, under pressure, against unsealed electrical systems orany exterior opening. Failure to follow this caution may result in damage to equipment(1) Cleaning. Clean the equipment of dirt, grease, and other contaminants but do not use vapordecreasing.(2) Painting. Remove rust and damaged paint by scraping, sanding, or buffing. Sand to a smooth finishand spot paint as necessary (TB 43-0209).(3) Preservation. After cleaning and drying, Immediately coat unpainted metal surfaces with oil orgrease, as appropriate (Chapter 3, Section I).CAUTIONPlace a piece of barrier materiel (Item 3 Appendix E) between desiccant bags andmetal surfaces to prevent corrosion.NOTEAir circulation under draped covers reduces deterioration from moisture and heat(4) Weatherproofing. Sunlight, heat, moisture (humidity), and dirt tend to accelerate deterioration.Install all covers (including vehicle protective closures) authorized for the equipment. Close and secure all openingsexcept those required for venting and draining. Seal openings to prevent the entry of rain, snow, or dust. Insertdesiccant when complete seal Is required. Place equipment and provide blocking or framing to allow for ventilationand water drainage. Support cover away from Item surfaces that may rust, rot, or mildew.4-244
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
