TM 9-2330-275-14&P
5-1.
BRAKEDRUM REPAIR (Con’t).
3.
Inspect braking Surface (6) for out-of-round at 45° intervals. Out-of-round should not exceed 0.006 in.
(0.15mm). If runout exceeds 0.006 in. (0.15 mm), reface braking surface (subpara b).
WARNING
DO NOT use a brakedrum that exceeds maximum wear specifications. Failure to
follow this warning may result in brake failure and serious injury or death to personnal.
4.
Measure inside diameter of brakedrum (1). Discard brakedrum if inside diameter exceeds 15.085 in. (38.32
cm).
WARNING
DO NOT use a brakedrum that exceeds maximum wear specifications. Failure to
follow this warning may result in brake failure and serious injury or death to personnal.
1.
Reface braking surface (6) with brakedrum lathe, removing a maximum of 0.01 in. (0.25 mm) per cut.
2.
Discard brakedrum (1) if inside diameter exceeds 15.085 in. (38.32 cm) after repair.
FOLLOW-ON TASKS:
. Install hub and brakedrum (pars 4-47).
5-2. TIRE REPAIR.
Refer to TM 9-2610-200-14 for instructions on tire repair.
5-2
