TM 9-2330-275-14&P
4-87. FRONT STABILIZER BAR REPLACEMENT (M832).
This Task Covers:
a. Removal
b. installation
Initial Setup:
Equipment Conditions:
Materials/Parta:
Dolly set parked on level surface with hand
Nonelectrical wire (as required)
brakes applied (pars 2-2).
(item 19, Appendix E)
Dolly set uncoupled from towing vehicle
Four locknuts
(para 2-16).
Four lockwashers
Tools/Test Equipment
. General mechanic’s tool kit
a.
REMOVAL I
NOTE
Perform the following steps at left and right sides of front dolly to remove front
stabilizer bar.
1.
Remove nonelectrical wire (11) from four screws (12). Remove four screws (12), lockwashers (13), and
washers (14), mounting bracket (15), rubber bushing (17), and retaining strap (16) connecting front stabilizer
bar (7) to front dolly. Discard nonelectrical wire and Iockwashers.
2.
Remove locknut (10), washer (9), and bushing (8) from front stabilizer bar (7), and remove front stabilizer bar
(7) from front dolly. Discard locknut.
3.
Remove locknut (4), three washers (3) and bushings (2), rod (6), and tube (5) from mounting bracket (1).
Discard locknut.
4-179
