TM 9-2330-275-14&P
4-68. REAR AXLE YOKE AND MOUNTlNG BRACKET MAINTENANCE (M832 SN J089-001
THRU 159 AND J017-160 THRU 350 ONLY) (Con’t).
2.
Remove locknut (7) and flat washer (6) from each end of threaded rod (8). Retain locknuts.
3.
Starting on either side of threaded rod (8), add fabricated spacer (9) and install locknut (7). Turn locknut (7)
against fabricated spacers (9) to pull threaded rod (8) through mounting bracket (1) and front yoke (1O).
Remove locknuts (7) and add additional fabricated spacers (9) as necessary until threaded rod (8) is
completely removed from mounting bracket (1). Discard threaded rod and locknuts.
4.
Remove tube spacer (13) from mounting bracket (1).
5.
Remove two flat washers (12) between mounting bracket (1) and front yoke (10).
6.
Remove two sleeve bearings (11) from mounting bracket (1). Discard sleeve bearings.
4-182
