TM 9-2330-275-14&P
4-69 FRONT AXLE YOKE AND MOUNTING BRACKET MAINTENANCE (M832 SN J089-001
THRU 159 AND J017-160 THRU 350 ONLY (Con’t).
2.
Remove two locknuts (8) and flat washers (7) from both ends of threaded rod (6). Retain locknuts.
3.
Starting on either side of threaded rod (6), add fabricated spacer (9) and install locknut (8). Turn locknut (8)
against fabricated spacers (9) to pull threaded rod (6) through mounting bracket (4) and front yoke (10). Add
additional fabricated spacers (9) as necessary until threaded rod (6) is completely removed from mounting
bracket (4) and front yoke (10). Discard threaded rod and locknut.
4.
Remove tube spacer (13) from mounting bracket (4).
5.
Remove two flat washers (12) between mounting bracket (4) and front yoke (10).
6.
Remove two bracket bushings (11) from mounting bracket (4). Discard bracket bushings.
inspect mounting bracket, front yoke, trunnion bearings, suspension bar, stabilizer bar, and all other removed
parts for excessive wear, tears, breaks, cracks, and bends. Replace damaged hardware.
1.
Install two new bracket bushings (11) in mounting bracket (4).
2.
Position two flat washers (12) between mounting bracket (4) and front yoke (10).
3.
Position tube spacer (13) on mounting bracket (4).
4-186
