TM-10-5411-235-13
SERVICE UPON RECEIPT
SERVICE UPON RECEIPT OF EQUIPMENT.
Inspection. Inspect shelter for damage incurred during shipment. If the shelter has been
damaged, report the damage in accordance with the instructions in the Warranty Technical
Bulletin, TB 10-5411-235-13. If the shelter is crated or pallet mounted, refer to the end item
technical manual for unpacking instructions. If the shelter is to be loaded onto a new
HMMWV, perform the following:
NOTE
For shelters to be replaced or moved from one vehicle to another and for any
component of the installation mounting kit which requires maintenance, perform
only the steps which are applicable.
Prior to performing the following procedures, remove Shelter-to-Vehicle Mounting
Kit and inventory per WP 0043, Table 2.
For LMS Type 1 Shelter Installation Instructions onto HMMWV, see WP 0038.
Check for any loose or missing hardware. Tighten or replace as needed.
Check that all LMS enclosure components are securely tied down. Tighten securing straps
as needed.
Lubrication. Perform initial lubrication on the LMS enclosure equipment/components as
outlined in WP 0008 00-1, Table 1.
accessories are present upon receipt of the LMS enclosure.
END OF WORK PACKAGE
0010 00-1/(2 Blank)
