TM 10-5411-224-14
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
SECTION I. REPAIR PARTS; TOOLS; SPECIAL TOOLS; TEST
MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT
EQUIPMENT
5-1. COMMON TOOLS. A complete list of common tools and tool kits may be found in Section III of Appendix B,
Maintenance Allocation Chart.
5-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. There are no special tools or test equipment needed to
maintain the LMS.
5-3. REPAIR PARTS. Repair parts for direct support maintenance are listed and illustrated in the Repair Parts and
Special Tools List (RPSTL), TM 10-5411-224-24P.
SECTION II. DIRECT SUPPORT TROUBLESHOOTING
5-4. GENERAL. This section contains troubleshooting information for malfunctions which may develop in the shelters.
Fault isolation is limited to those components which may be repaired or replaced at the direct support level. Table 5-1
lists the common malfunctions you may encounter during operation or maintenance of the shelter. Each malfunction
identifies a test or inspection followed by a corrective action. These tests or inspections and corrective actions should be
performed in the order listed. This manual cannot list all malfunctions that may occur. If you encounter a malfunction
that is not listed or that cannot be corrected by the listed corrective actions, notify your supervisor.
5-1
