TM 10-5411-205-13
3-19.
Door Handle Assembly and Latching Mechanism (cont).
(4)
(5)
(6)
(7)
(8)
(9)
(10)
Punch out grooved pin (9) from underside of latch arm assembly (10) and
remove grooved pin (9) to release the latch arm assembly (10). Pull outside
handle assembly (8) out of door.
Remove o-ring (15) from place on outside handle shaft (8).
Turn the bearing sleeve nut (16) counterclockwise to release the handle shaft
sleeve (17) and remove nut (16) and shaft sleeve (17).
Punch out spring pin (11) and release the roller extension (12) and roller latch
(13) from latch arm (14).
Punch out spring pin (1) and release flat washer (2), pin (18), and latch rod
assembly (5).
Remove nut (19) to release washer (20), spacer (21), latch arm assembly (10),
spacers (22, 24, and 25), latch arm detent (23), (at the bottom latch installation
only), and bolt (26).
Remove rivet (27) attaching padlock and chain (28) to panel and remove
padlock. (Refer to paragraph 3-9.a for rivet removal instructions.)
d. Assemble.
(1)
(2)
(3)
(4)
NOTE
Assembly procedures are similar for top and bottom sections of door
latch assembly.
Place mounting end of padlock and chain (28) over mounting hole and secure
with rivet (27). (Refer to paragraph 3-9.a for rivet installation instructions.)
Place roller extension (12) and roller latch (13) on to latch arm (14) and secure
with spring pin (11).
NOTE
When installing the latch arm detent (23) at the bottom section of
the assembly, have the latch mechanism fully open so that the
raised surface is engaged in the hole of the latch arm assembly
(10). Then secure all components by tightening nut (19).
Apply conductive compound under head of each bolt (26) and place bolt through
mounting hole on door.
Insert spacers (24 and 25), latch arm detent (23), spacer (22), (at top of installa-
tion), latch arm assembly (10), spacer (21), and washer (20) on bolt (26), and
secure with nut (19).
3-38
