TM 10-5411-205-133-20.Keeper Assembly.This task covers: a.Inspectb. ReplaceINITIAL SETUPToolsGeneral Mechanic’sMaterials/PartsAutomotive Tool KitN o nea .Inspect. (Figure 3-22)(1) Inspect for wear and other physical damage.(2) Inspect for secure mounting.(3) Inspect latch lock assembly (8) for wear or damage.b.Replace. (Figure 3-22)(1)( 2)( 3 )( 4 )( 5)( 6)NOTEThe middle keeper on each door is tapped for attachment of a latchlock assembly. Maintenance procedures are the same for all keep-ers and on both the outer door and inner door assemblies.Remove and retain hex-head screw (1), lock washer (2), and flat washer (3) fromtop (upper) hole of keeper assembly (4).Remove and retain hex-head screw (5), lock washer (2), and flat washer (3) frombottom (lower) hole of keeper (4) attaching each of the keepers (4) and shim (6)and laminated shim (7) to wall and remove.If only latch lock assembly (8) has to be removed, remove and retain hex-headscrew (5), lock washer (2), and flat washer (3) attaching tab of latch lock assem-bly (8) to center keeper at the bottom (lower) hole, and remove latch lock.Position laminated shim (7), shim (6), and each keeper (4) in place and secureto shelter wall at top hole using hex-head screw (1), lock washer (2), and flatwasher (3).Secure keeper (4) to wall at bottom hole using hex-head screw (5), lock washer(2), and flat washer (3).If only latch lock assembly (8) has to be installed, position latch lock tab inplace over bottom mounting hole of center keeper (4), and secure using hex-head screw (5), lock washer (2), and flat washer (3).3-41
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
