Hinge Assembly

TM-10-5411-205-13 Shelter Electrical Equipment S-250/G (Unshielded) (NSN 5411-00-999-4935) (Shielded) (NSN 5411-00-189-6076) Manual
Page Navigation
52

TM 10-5411-205-13 3-21. Hinge Assembly. This task covers: a. Inspect b. Remove c. Disassemble d. Assemble e. Install INITIAL SETUP T o o l s Materials/Parts General Mechanic’s Automotive Tool Kit Sealer (Item 28, Appendix D) Conductive Compound (Item 33, Appendix D) b . NOTE The following repair procedures are the same for the inner door (paragraph 3-23) hinge assembly. Inspect. (Figure 3-23) (1) Inspect for damaged or non-functioning hinge assembly, (2) Inspect for missing attaching hardware. Remove. (1) Remove and retain three nuts (1) and flat washers (2) attaching each hinge from the inside of door panel. (2) Remove and retain three hex head screws (3) and flat washers (2) and remove hinge assembly (4) and laminated shim (5). Disassemble. (1) Grind off end of pin (6) and remove pin (6) and flat washer (7). (2) Remove hinge leaf (8) and two flat washers (9) from bracket (10). Assemble. (1) Position hinge leaf (8) and and flat washers (9) in place inside bracket (10) and secure in place with pin (6). (2) Place flat washer (7) into pin (6) at opposite end of bracket (10) and peen end of pin (6) over to hold washer (7). c . d . 3-43

Privacy Statement
Press Release
Contact