INSTALLATION AND PREPARATION FOR USE (CONT

INSTALLATION AND PREPARATION FOR USE (CONT - TM-10-5411-203-13_35

INSTALLATION AND PREPARATION FOR USE (CONT - TM-10-5411-203-13_37

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
31

TM 10-5411-203-13 2-4. INSTALLATION AND PREPARATION FOR USE (CONT) b. Installing Complexing Kit Passagewav - Type II, Class A and Class B (ISO Shelter to TEMPER) (Cont) (12) Place header bar (1) through support straps (2) along roof of connector assembly (3). (13) Connect upright bars (4) to header bar (1) using the following steps: (a) Insert both upright bars (4) into header bar (1). (b) Insert locking pins (5) into holes to secure upright bars (4) to header bar (1). WARNING The Complexing Kit Passageway components include two ramps and a stairway. The ramps weigh approximately 145 pounds (65.77 kg) and 195 pounds (88.45 kg) re- spectively, and the stairs (complete assembly) weigh approximately 70 pounds (31.75 kg). Four persons are required to handle each of these components. Attempting to lift or carry any one of them by yourself could result in serious injury or damage to the equipment. CAUTION Do not permit ramp or stairway to drop. Support ramp or stairway throughout lowering procedure to prevent damage to connector assembly. (14) For Type II, Class A, place ramp inside Complexing Kit Passageway. 2-25

Privacy Statement
Press Release
Contact