INSTALLATION AND PREPARATION FOR USE (CONT

INSTALLATION AND PREPARATION FOR USE (CONT - TM-10-5411-203-13_33

INSTALLATION AND PREPARATION FOR USE (CONT - TM-10-5411-203-13_35

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
29

TM 10-5411-203-13 2-4. INSTALLATION AND PREPARATION FOR USE (CONT) b. Installing Complexing Kit Passageway - Type II, Class A and Class B (ISO Shelter to TEMPER) (Cont) WARNING When installing or removing frame assembly, take care to avoid getting fingers caught in hinged joints. Failure to do so may result in serious injury. NOTE The next step requires two persons on the outside and two persons on the inside of the ISO shelter. (8) Place bottom of frame assembly (1) over lip (2) of ISO shelter opening (3). WARNING When installing or removing frame assembly, avoid getting fingers caught in hinged joints. Failure to do so may result in serious injury. CAUTION Ensure fabric of connector assembly is not caught in frame assembly hinges when frame assembly is installed. NOTE The next procedure is done inside ISO shelter. (9) Erect frame assembly (1) using the following steps: (a) Position one person on each side of frame (1). (b) As one person holds bottom of frame (1), other person pushes top of frame to top lip of ISO shelter opening. (c) Press on frame sides until frame assembly is fully seated in shelter opening and insert locking pins (4). 2-23

Privacy Statement
Press Release
Contact