TM 10-5411-203-132-4. INSTALLATION AND PREPARATION FOR USE (CONT)a. InstallingComplexingKitPassageway-TypeI(ISOSheltertoISOShelter)(Cont)(12)Adjust doors using the following steps:(a) By moving pedestal assemblies (1) and pivot assemblies (2) on each door, adjust gap (3) between doors andgap (4) between doors and sides of the passageway frame. Gaps should be approximately 1/8 in. After aneven gap is obtained, tighten mounting screws on pedestal assemblies (1) and pivot assemblies (2).(b) Adjust gap at top of door and top of passageway frame by turning height adjusting screw (5) clockwise toraise door.(c) Test doors by swinging one, then the other thru full range of motion. If any interference is encountered,additional adjustment may be necessary.2-19
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
