TM 10-5411-203-13
2-4.
INSTALLATION AND PREPARATION FOR USE (CONT)
a.
Installing Complexing Kit Passageway - Type I (ISO Shelter to ISO Shelter) (Cont)
WARNING
The Complexing Kit Passageway components include two ramps and a stairway. The
ramps weigh 145 pounds (65.77 kg) and 195 pounds (88.45 kg) respectively, and the
stairway (complete assembly) weighs approximately 70 pounds (31.75 kg). Four
personnel are required to handle each of these components, Attempting to lift or carry
any one of them by yourself could result in serious injury or damage to the equipment.
CAUTION
Do not permit ramp to drop. Support ramp throughout lowering procedure to prevent
damage to connector assembly.
Do not step on fabric floor of connector assembly. Damage to connector assembly may
result.
(8) Place ramp (1) inside complexing kit passageway (2) using the following steps.
(a) Lift ramp (1) and place on side.
(b) Lift ramp and pass end through opening to personnel in other ISO shelter (3).
(c) Lower ramp (1) into position.
2-13
