TM 10-5411-201-14
T.O. 35E4-178-1
3-7.
ENDWALL CLOSEOUT PANEL REPLACEMENT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Standard Tools
General mechanics tool kit
Personnel- - 2
REMOVAL
W A R N I N G
When hinged floor is in deployed position, do not
disconnect support cable from hinged floor until
stop plates on load balancer (inside shelter) have
been locked with quick release pins to prevent
return of support cable.
1.
Move flexible electrical cable to facilitate removal of endwall
closeout panel.
2.
Inside shelter, loosen twelve captive screws (1) and remove endwall
closeout panel (2).
INSTALLATION
NOTE
Endwall closeout panel (2) is stowed on outside of
hinged sidewall when not in use.
Position endwall closeout panel (2) against shelter endwall and secure by
tightening twelve captive screws (l), placing bottom end in first.
CHANGE 2
3-9
