TM 10-5411-201-14
T.O. 35E4-178-1
4-12. (cont)
NOTE.
Tag all wires for reconnection.
4.
Remove two wire nuts (9) and separate two sets of wires between ballast
(16) and contacts on light frame (3).
5.
Remove four wire nuts (9) and separate four sets of wires between
ballast (16) and contacts at opposite end of light frame (3).
6.
Remove nuts (17) and remove ballast (16) from light frame (3).
7.
Drill out rivets (18) and remove two light support plates (19) from
light frame (3).
(Refer to paragraph 4-33)
CLEANING, INSPECTION
1.
Clean hinged roof area ceiling ‘light and component surfaces.
2.
Inspect mounting surfaces for corrosion and damage.
3.
Inspect for and replace if necessary:
a.
Missing or damaged components.
b. Corrosion or paint damage.
4-34
CHANGE 2
