TM 10-5411-201-14
T.O. 35E4-178-1
4-11. (cont)
6.
Remove installation screw (9) attaching terminal lug (10) on third
wire from electrical cord (8).
7.
Remove locknut (13) and remove electrical cord (8) with liquid tight
connector (11) and plug (12) from light frame (6).
8.
Remove nuts (14) and remove ballast (15) from light frame (6).
9.
Drill out rivets (16) and remove two light support plates (17) from
light frame (6).
(Refer to paragraph 4-33. )
CLEANING, INSPECTION
1.
Clean hinged roof area ceiling light and component surfaces.
NOTE
Do not use water to clean hinged roof area ceiling lights.
2.
Inspect mounting surfaces for corrosion and damage.
3.
Inspect for and replace if necessary:
a.
Missing or damaged components.
b. Corrosion or paint damage.
REPAIR
Repair corrosion or paint damage. (Refer to paragraph 4-44)
ASSEMBLY
1.
Position two light support plates (17) on light frame (6) and install
rivets (16).
(Refer to paragraph 4-33)
CHANGE 2
4-29