TM 10-5410-284-13&P
TM 10602A-13&P
LIGHTWEIGHT MAINTENANCE ENCLOSURE (LME)
0005 00
OPERATION UNDER USUAL CONDITIONS
0005 00-3
Install the door header assembly (1) by aligning its holes (2) with those in the lower arch assembly (3)
with the carrier hooks (4) facing towards the outside of the LME. Secure with the attached quick release
pin (5). Position the assembly flat on the ground.
Repeat the steps in (2) above, installing a cable header assembly into the upper arch assembly, instead
of a door header assembly. Continue this procedure until all five assemblies are completed. Position
them flat on the ground, with one assembly containing the door header at each end of the arrangement,
and those containing the cable headers in between.
