TM 10-5410-284-13&PTM 10602A-13&PLIGHTWEIGHT MAINTENANCE ENCLOSURE (LME)0005 00OPERATION UNDER USUAL CONDITIONS0005 00-1PACKINGThe LME is shipped in separate transport covers and bags, each of which is labeled with its contents andlifting requirements. Always ensure that sufficient personnel are available for lifting and carrying thecomponents. Refer to the applicable procedures in this manual or the panel illustration on the inside ofthe end fabric panels for assembly and setup procedures. Identify and inventory all components beforebeginning to set up the LME.SITING REQUIREMENTSDuring site selection for the LME the following considerations are relevant:The function to be performed with the LME. For example, when used as a maintenance facility, vehicularaccess and proximity to a roadway is important. However, when used as a troop assembly or billetingfacility, concealment and other factors may be more important.The site must be free of debris. The ground should be level, varying no more than three (3) inches in ten(10) feet on unprepared soil. Choose a site that affords some protection from prevailing winds.The site should also be firm and dry, away from any potential flood areas, as well as clear of trees whichmay create problems in high winds.The LME is 23' 11 5/16" wide at the base and 32 feet long, requiring an area approximately 40x40 ft(1600 sq ft) to erect the structure, not including the additional space required to emplace the stakes andguy lines as shown below:Figure 0005 00-1 Staking Diagram
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
