TM 10-5410-229-13&P
Section I. LUBRICATION INSTRUCTIONS.
4-1.
GENERAL. None of the MCPS components require lubrication.
Section II. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT
EQUIPMENT.
4-2.
COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
4-3.
SPECIAL TOOLS. Refer to Appendix B, Section II, Tool and Test Equipment Requirements, Maintenance
Allocation Chart, for additional tool and equipment requirements.
4-4. REPAIR PARTS. The repair parts required for unit level maintenance are listed and illustrated in Appendix C, Repair
Parts and Special Tools List.
Section III. SERVICE UPON RECEIPT.
4-5.
UNPACKING. The MCPS components, will be packaged in a cleated plywood crate as per FED-SPEC-PPP-B-601,
that is 7511 long, 27" wide, and 42" deep. The box is strapped to a wooden pallet. Upon receipt, check for damage.
Report any damage to the carrier and your supervisor.
CAUTION
Unpack components carefully. Improper or hasty handling may result in
damage to the MCPS components and accessories.
a.
Procedure. Unpack the equipment in the following sequence:
(1)
Cut and remove retaining straps holding crate to pallet. Remove crate from wooden pallet.
(2)
Position crate to be unpacked with the top facing up.
(3)
Open the crate, remove padding material, and set it aside. Do not cut, rip, or otherwise damage the
packing material.
(4)
Lift the components from the crate.
4-2
