TM 10-5410-221-24
blind nut (29) by drilling using a drill bit having the same
panel using procedures outlined. in paragraph 2-25. If
diameter as the blind nut.
possible, straighten any bent plates, latches, angles, or
(6) Remove mobilizer bracket (33) by
extrusions. Repair velstat floor covering per paragraph
removing screws (30) and washers (31, 32) (7)
2-25.
e. Overhaul.
Overhaul the fixed floor panel
Remove support assembly (38) by removing bolt
(35) and washers (36, 37) Remove spacer (39), separate
assembly as required to return to a serviceable condition
channel insert (34) from support assembly (38) by
per chapter 10, section III.
f. Assembly. Assemble the fixed floor panel in
removing detent pin (41).
(8) Remove screw (42), screw (43) and
reverse order of disassembly using figure 10-12 as a
washer (44) to remove ground rod (45).
guide and observing the following.
(9) Remove rivet (46) and remove sea' angle
(1) Cement guards (48, 49) using procedures
(47) from edge of panel.
outlined in paragraph 2-20.
(10) Remove rubber guards (48, 49) by peeling
(2) Replace inserts per paragraph 2-23b.
from cemented area per paragraph 2-20d.
(3) Replace rivets per paragraph 2-22c.
(11) Remove bolt (50), washer (51) and
(4) Replace rivnuts and blind nuts per
remove skid assembly (52). Disassemble skid assembly
manufacturer's recommended procedures.
(52) by removing bolt (53) to separate channel (54) from
g. Installation. Install the fixed floor panel in
extrusion (57). Remove nut plate (56) by removing rivet
reverse order of removal using figure 10-12 as a guide
(55).
and observing procedures outlined for replacement of
d. Repair. Repair damage to honeycomb
fixed end and fixed roof panel assemblies in paragraphs
.
10-11, 10-12, and 10-13.
10-26
