TM 9-2330-390-14&P
4-138.1. COLD START KIT INSTALLATION (Con't).
If enclosure assembly is not installed in proper location at hydraulic reservoir,
interference with telescopic brace will occur during operation, causing damage to
enclosure assembly.
2.
Position enclosure assembly (1) with mounting angles (4 and 6) against hydraulic reservoir (11). On front dolly,
top mounting angle (4) should be at top of reservoir. On rear dolly, top mounting angle should be 6 in. (15 cm)
down from top of reservoir.
3.
Secure enclosure assembly (1) to hydraulic reservoir (11) with four mounting angles (4, 6, and 10), four
threaded rods (9), eight flatwashers (8), and locknuts (7).
Change 3 4-400.1
