ENCLOSURE ASSEMBLY REPAIR (COLD START KIT)

COLD START KIT INSTALLATION - cont - TM-9-2330-390-14P_667

ENCLOSURE ASSEMBLY REPAIR (COLD START KIT) - cont

TM-9-2330-390-14P Semitrailer Tank: 5 000 Gallon (Portable Water Dispensining) XM1098 (NSN 2300-01-330-2779) Manual
Page Navigation
624

a. SWITCH REPLACEMENT TM 9-2330-390-14&P 4-138.2. ENCLOSURE ASSEMBLY REPAIR (COLD START KIT). This Task Covers: a. Switch Replacement b. Lamp Replacement Initial Setup: Equipment Conditions: Tools/Test Equipment: • Engine starter switch set to OFF position (see l General mechanic’s tool kit (Item 30, Appendix G) paragraph 2-20). • Enclosure assembly switch set to OFF position. Materials/Parts: l Marker tags (Item 28, Appendix F) NOTE All wires should be tagged before removal. Refer to paragraph 4-18 for tagging instructions. 1. Loosen three screws (5) and open cover (1) of enclosure assembly (6). 2. Remove two terminal screws (4) and disconnect two wires (3) from switch (2). Change 3 4-400.3

Privacy Statement
Press Release
Contact