TM 9-2330-390-14&P4-138.2. ENCLOSURE ASSEMBLY REPAIR (COLD START KIT) (Con’t).3.4.5.6.7.8.NOTESwitch mounting hardware may be reused,if not damaged.Note position of inner nut on switch to en-sure proper installation.On outside of cover (1), raise guard (9) out of wayof switch (2). Remove nut (7) and lockwasher (8)from shaft of switch and remove switch. Removelocking ring (10) and nut (11).Install nut (11) and locking ring (10) on shaft ofswitch (2).Position switch (2) through cover (1) with tang oflocking ring (10) indexed with keyway in cover.On outside of cover (1), install lockwasher (8) andnut (7) on shaft of switch (2).Connect two wires (3) to switch (2) with two terminal screws (4).Close cover (1) and tighten three screws (5).4-400.4 Change 3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business