TM 9-2330-390-14&P
4-76.
WHEEL AND TIRE MAINTENANCE (Con’t).
C.
INSTALLATION
1.
Install wheel and tire (2) on studs (1).
Wheel nuts are left-hand and right-hand threaded. Left-hand wheel nuts must be
installed on left-hand studs (left side of dolly). Right-hand wheel nuts must be installed
on right-hand studs (right side of dolly). Failure to follow this warning may cause wheel
nuts to loosen when dolly set is towed, resulting in Injury to personnel.
2. Install ten wheel nuts (3) on studs (1) and tighten until snug.
Dolly set hydraulic control valve may be operated to lower wheel and tire to ground
(see paragraph 2-21).
3. Lower dolly set until wheel and tire (2) are on ground.
4. Evenly tighten ten wheel nuts (3) using a crisscross pattern. Torque wheel nuts in same crisscross pattern to
450-500 lb.-ft. (610-678 N•m).
NOTE
4-199/(4-200 Blank)
