TM 9-2330-390-14&P
Change 4 4-197
4-76.
WHEEL AND TIRE MAINTENANCE.
This Task Covers:
a.
Removal
b.
Repair
c.
Installation
Initial Setup:
Equipment Conditions:
• Parking brake lever set to ON position (see paragraph
2-2).
Personnel Required: Two
References:
• TM 9-2610-200-14
Tools/Test Equipment:
• General mechanic's tool kit (Item 30, Appendix G)
• Hydraulic jack, 12 ton (Item 17, Appendix G)
• Trestle (Item 32, Appendix G)
• Socket wrench set, 3/4 in. drive (Item 39, Appendix G)
• Torque wrench, 0-600 Ib.-ft. (Item 43, Appendix G)
WARNING
Use extreme caution when handling heavy parts. Lifting device is required when
parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two
person lift, and over 150 lb (68 kg) for a three or more person lift. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may
cause serious Injury or death to personnel.
NOTE
•
Tires of the same manufacturer should be used on the same axle. If a replace-
ment tire is of a different manufacturer than the other tire on the same axle, it is
recommended that the other tire also be changed.
•
Earlier model dolly set wheel and tires have tubes. Later model dolly set wheel
and tires are tubeless. DO NOT mix tubed and tubeless tires on the same vehi-
cle.
NOTE
Towing vehicle tire changing tools may be used.
1.
Chock wheel and tire on unaffected side.
a.
REMOVAL
