TM 9-2330-390-14&P
4-48.
REAR DOLLY TAILLIGHT ASSEMBLY CABLE ASSEMBLY REPLACEMENT (Con't).
b.
INSTALLATION
1.
Install taillight assembly cable assembly (11) through cord connector (25) and tighten nut (24).
2.
Install sealing ring (27) on wires of taillight assembly cable assembly (11).
3.
Route wires of taillight assembly cable assembly (11) through hole In rear junction box (20).
4.
Position sealing ring (27) and cord connector (25) at rear junction box (26). Install locknut (26) on taillight
assembly cable assembly (11) and tighten locknut.
5.
Install white and green ground wires (5) on upper right screw (18) with nut (17).
NOTE
• Right side cable assembly wires are connected to positions 3, 4, 5, 6, and 8 of
terminal block.
• Left side cable assembly wires are connected to positions 1,2,4,5, and 8 of terminal
block.
6.
Install five cable assembly wires (23) to terminal block (21) with five screws (22).
7.
Close cover (16) and tighten three screws (19).
4-98
