IDENTIFICATION LIGHT CABLE ASSEMBLY REPLACEMENT

REAR DOLLY TAILLIGHT ASSEMBLY CABLE ASSEMBLY REPLACEMENT - cont - TM-9-2330-390-14P_365

IDENTIFICATION LIGHT CABLE ASSEMBLY REPLACEMENT - cont - TM-9-2330-390-14P_367

TM-9-2330-390-14P Semitrailer Tank: 5 000 Gallon (Portable Water Dispensining) XM1098 (NSN 2300-01-330-2779) Manual
Page Navigation
330

TM 9-2330-390-14&P 4-49. IDENTIFICATION LIGHT CABLE ASSEMBLY REPLACEMENT. This Task Covers: a. Removal b. Installation Initial Setup: Equipment Conditions: Materials/Parts: • Intradolly cable disconnected from rear junction box • Marker tags (Item 28, Appendix F) (see paragraph 2-7). • Tie-down straps • One lockwasher Tools/Teat Equipment: • Two locknuts • General mechanic’s tool kit (Item 30, Appendix G) NOTE • All wires should be tagged before removal. Refer to paragraph 4-18 for tagging instructions. • Refer to electrical wiring diagrams for assistance (see paragraph 4-50). a. REMOVAL NOTE 1. Disconnect cable assembly connector plug (2) from identification light connector plug (1). 2. Remove locknut (3), two ground wires (4 and 5), flatwasher (6), lockwasher (7), and panhead screw (6) from identification light (9) and pivoting tray (10). Discard locknut and lock washer. 4-101

Privacy Statement
Press Release
Contact