TM 9-2330-390-14&P
4-49.
IDENTIFICATION LIGHT CABLE ASSEMBLY REPLACEMENT (Con’t).
b.
INSTALLATION
1.
Install identification light cable assembly (14) through cord connector (28) and tighten nut (26).
2.
Install sealing ring (26) on wires of identification light cable assembly (14).
3.
Route wires of identification light cable assembly (14) through hole in rear junction box (22).
4.
Position sealing ring (26) and cord connector (28) at rear junction box (22). Install locknut (27) on identification
light cable assembly (14) and tighten locknut.
4-104
