TM 9-2330-390-14&P
4-48. REAR DOLLY TAILLIGHT ASSEMBLY CABLE ASSEMBLY REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
lntradolly cable disconnected from rear junction box
Marker tags (Item 28, Appendix F)
(see paragraph 2-7).
Tie-down straps
One locknut
Tools /Test Equipment:
Two lockwashers
General mechanics tool kit (Item 30, Appendix G)
NOTE
Left and right side talllight assembly cable assemblies are replaced the same way
except as noted. Right side taillight assembly cable assembly la Illustrated.
All wires should be tagged before removal. Refer to paragraph 4-18 for tagging
Instructions.
Refer to electrical wiring diagrams for assistance (see paragraph 4-50).
a .
REMOVAL
1.
Cut tie-down strap from connector plugs (14 and
15). Disconnect five connector plugs (14) of tail-
light assembly cable assembly (11) from five light
connector plugs (15). Discard tie-down strap.
2.
Remove locknut (6), cable assembly ground wire
(5) flatwasher (4) lockwasher (3) panhead
screw (1) and lockwasher (2). Discard locknut
and lockwashers.
4-95
