TM 9-2330-390-14&P4-45.BATTERY CABLES REPLACEMENT (Con’t).4.5.6.Remove locknut (17), fiatwasher (16), and negative (-) ground cable (14) from crankcase (1). Discard locknut.Remove nut (6), springwasher (5), engine wiring harness lead (4), and positive (+) cable (3) from starter (2).Discard springwasher.Remove tie-down straps (15) from positive (+) cable (3) and negative (-) ground cable (14). Discard tie-downstraps.Inspect battery terminals and cable end connections for dirt or corrosion. Clean in accordance withTM 9-6140-200-14.Always connect negative (-) ground cable to negative (-) terminal of battery LAST toavoid a short should a tool contact cables. Failure to follow this warning may result inserious injury or death to personnel.Install positive (+ ) cable (3) and engine wiring harness lead (4) on starter (2) with new springwasher (5) and nut(6).Install negative (-) ground cable (14) on crankcase (1) with flatwasher (16) and new locknut (17).Install positive (+) cable (3) on battery positive (+) terminal (13). Tighten nut (7).Install negative (-) ground cable (14) on battery negative (-) terminal (11). Tighten nut (10).Wrap positive (+) cable (3) and negative (-) ground cable (14) with new tie-down straps (15).1.2.3.4.5.Avoid overtightening of strap, which may damage strap or buckle.6.Install cover (8) on battery case (12). Fasten strap (9).4-83
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business