TM 9-2330-390-14&P
CHAPTER 3
OPERATOR/CREW MAINTENANCE
Section I. LUBRICATION INSTRUCTIONS
Paragraph
Page
Number
Paragraph Title
Number
3 - 1
G e n e r a l
3-1
3-2
Specific Lubrication Instructions
3-1
Lubrication Chart
3-2
3-1. GENERAL.
NOTE
These instructions are MANDATORY
a.
The M1022A1 Dolly Set must receive lubrication with approved lubricants at recommended intervals in
order to be mission-ready at all times.
b.
The Lubrication Chart shows lubrication points, items to be lubricated, the required lubricants, and
recommended intervals for lubrication. Any special lubricating instructions required for specific components are
contained in the NOTES section of the chart.
c.
The KEY provides Information needed to select the proper lubricant for various temperature ranges and
uses, and identifies the intervals.
d.
Recommended intervals are based on normal conditions of operation, temperature, and humidity.
When operating under extreme conditions, lubricants should always be changed more frequently. When in doubt,
notify your supervisor.
3-2. SPECIFIC LUBRICATION INSTRUCTIONS.
a.
Keep all lubricants In a closed container and store in a clean, dry place away from extreme heat. Keep
container covers clean and do not allow dust, dirt, or other foreign material to mix with lubricants. Keep lubrication
equipment clean and ready for use.
b.
Maintain a record of lubrication performed and report any problems noted during lubrication. Refer to
DA Pam 738-750 for maintenance forms and procedures to record and report any findings.
c.
Keep all external parts of equipment not requiring lubrication free of lubricants. After lubrication, wipe off
excess oil or grease to prevent accumulation of foreign matter.
d.
Refer to FM 9-207 for lubrication instructions in cold weather.
e. After operation in mud, sandy, or dusty conditions, clean and inspect all points of lubrication for
contaminated lubricants. Change lubricants as required.
3-1
