TM 9-2330-390-14&P
LUBRICATION CHART
DOLLY SET: LIFT, TRANSPORTABLE SHELTER,
7-1/2 TON, M1022A1
(NSN 2330-01-378-9997)
(EIC: CML)
This Lubrication Chart Is for Crew/Operator (C) or
Unit (0) Maintenance. Lubrication Intervals (on-con-
dition or hard time) are based on normal operation.
Lubricate more during constant use and less during
Inactive periods. Use correct grade of lubricant for
seasonal temperature expected.
goggles and gloves, and use only in a well-
ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe
vapors. DO NOT use near open flame or
excessive heat. The solvent’s flash point is
100°F-138°F (38°C-59°C). if you be-
come dizzy while using cleaning solvent,
For equipment under manufacturer’s warranty, hard
immediately get fresh air and medical help.
time oil service intervals shall be followed. intervals
if solvent contacts eyes, immediately wash
shall be shortened if lubricants are known to be con-
your eyes and seek medical attention.
taminated or If operation Is under adverse conditions
(e.g., longer than usual operating hours, extended
Idling periods, extreme dust, etc.).
Clean all fittings and area around lubrication points
with dry cleaning solvent (Item 27, Appendix F) or
Oil filters shall be serviced/cleaned/changed, as
equivalent before lubricating equipment. After lubri-
applicable, when:
cation, wipe off excess oil or grease to prevent accu-
mulation of foreign matter.
a. They are known to be contaminated or
clogged; or
Before you start your lubrication service:
b. At prescribed hard time intervals.
ALWAYS
This dolly set is not enrolled In the Army Oil Analysis
Program (AOAP). HARD TIME INTERVALS APPLY.
On illustrations, a dashed line (- - -) means lubrica-
tion points on both sides.
a. Clean grease fittings before lubricating.
b. Use the Lubrication Chart as your guide.
NEVER
a. Use wrong type/grade grease.
Dry cleaning solvent, P-D-680, is toxic and
flammable.
Always
wear protective
b. Use too much lubricant.
3-2
