TM 9-2330-390-14&P2-32. OPERATION ON UNEVEN TERRAIN (Con?).(10) Remove stowage strap (14). Repeat step (5) to remove lockout bracket assemblies (15) fromposition at midpoint of axle (8) and pivot axle bracket (12).NOTEWelded pads on axle and plvot axle bracket ldentify correct lnstallation location oflockout bracket assemblies.(11) Install top lockout bracket (9), four sleeves (7), bottom lockout bracket (6) four bolts (5), and nuts(10) on each end of axle (8) and pivot axle bracket (12). Handtighten nuts.(12) Wrench tighten nuts 1 ¼ to 2 flats.(13) Install safety pins (11) through bolts(5) to secure nuts (10).(14) Lock pivoting tray lockout brace (1) tolower bracket (2) with hitch pin (4) and safety pin (3).2-33. FORDING OPERATIONS.NOTEThe dolly set, with or without shelter, can hardbottom ford either freshwater orsaltwater up to a depth covering the wheel hubs.a.After fording, apply the brakes a few times to help dry the brake linings. Ensure that the brakes areoperating properly before driving at normal speeds.NOTEIf dolly Set was required to ford water that covered the wheel hubs, have UnitMaintenance check, clean, and lubricate wheel bearings.b.Lubricate the dolly set in accordance with Instructions in Chapter 3, Section I.2-149
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
