TM 9-2330-390-14&P
2-12.
All-ACHING FRONT AND REAR DOLLIES TO SHELTER (SHELTER ON GROUND)
(SIDE LIFT OPERATION) (Con’t).
g.
At front and rear top beams (2), remove two
detent pins (14) and rotate top hooks (15) 180° away
from shelter engagement position. Install detent pins.
h. Remove two detent pins for crossbrace
assemblies (16) from storage box on front dolly.
Use extreme caution when climbing and working on top of shelter during side lift
operations. Ensure that top of shelter is free of ice or debris which could cause slips
and fails. When working with twist locks from on top of shelter, maintain a
three-point contact with shelter as much as possible. When on top of shelter, always
be aware of where other personnel and tools are located to prevent accidental
bumps and trips. Failure to follow this warning may cause serious injury to
personnel.
All personnel standing on ground must stand clear when crossbrace assemblies are
being removed from top beam. if a crossbrace assembly is dropped, serious injury
or death to personnel could result.
i.
At front and rear, remove detent pin (17) and crossbrace assembly (16) from stowage in top beam (2).
Rest crossbrace assemblies on top of shelter (6).
2-87
