TM 9-2330-390-14&P
2-11.
RAISING DOLLY SET WITH OR WITHOUT SHELTER AND COUPLING TO TOWING
VEHICLE (Cont).
NOTE
· A 12-volt or 24-volt intervehicular cable may be used depending on towing vehicles
electrical system. 12-volt intervehicular cable is connected to 12-volt receptacle
connector (20) of signal conditioning box (22). 24-volt intervehicular cable is
connected to 24-volt receptacle connector (21). This task shows a 24-volt
intervehicular cable in use.
· it raising a rear doily set in preparation for tandem towing, skip step I.
i.
Connect intervehicular cable (19) to towing vehicle receptacle connector. Secure intervehicular cable
under detent pin (16).
j.
Inflate air bags (see paragraph 2-22).
NOTE
If operating on uneven terrain, refer to paragraph to 2-32 for instructions on locking
the axle-to-pivot axle bracket coupling.
k.
At front and rear, pull down on two lift cylinder levers (24) to raise dolly set with or without shelter (13) off
the ground to a sufficient height to allow engagement of two transportation lockouts (27) to suspension links (26).
2-80
