TM 9-2330-390-14&P2-9. ATTACHING FRONT AND REAR DOLLIES TO SHELTER (Can’t).j.At front and rear, extend or retract positioning cylinders as required to aline twist locks (13) in bottombeam (5) with holes in comer blocks (9) of shelter (6). When alined, push twist locks into corner blocks.k.At front and rear, push up on two lift cylinder levers (1) to bring bottom beam (5) flush against shelter (6).Use extreme caution when installing twist locks. Keep hands and/or feet clear of tophooks, top and bottom beams, and from between beams and shelter. Failure to followthls warning may cause serious Injury to personnel.I.At front and rear, ensure that twist locks (13) are fully pushed into comer blocks (9) in bottom of shelter(6). Rotate twist locks 90” so that twist lock pins (12) are horizontal. Tighten nuts (10) fingertight.m. At front and rear, push up on positioning cylinders lever (8) and raise bottom beam (5) to force heads oftwist locks (13) up against top on inside of corner blocks (9). Use twist lock wrench (Item 3, Appendix D) to tightennuts (10). Install safety pins (11) through twist locks to secure nuts.2-61
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business