TM 9-2330-390-14&P
2-8. LOWERING DOLLY SET WITH OR WITHOUT SHELTER AND DETACHING FRONT
AND REAR DOLLIES (Con’t).
m. At front and rear, remove safety pins (30). Use twist lock wrench (Item 3, Appendix D) to loosen nuts (29)
at top and bottom beams (15 and 4). Rotate twist locks (31) 90° and remove from top beams and shelter (21). Stow
removed twist locks in toolbox (32) on front dolly.
n.
At bottom beams (4) rotatetwist locks (31) 90° . Pull out on- but DO NOTremove-twist locks. Ensure
that heads of twist locks are alined with holes in corner blocks (35) of shelter (21).
o.
At front and rear, pull down on two lift cylinder levers (22) to extend lift cylinders. Stop when bottom beam
(4) is approximately 6 in. (15 cm) from shelter (21) and twist locks (31) are free of comer blocks (35).
p.
At front and rear, pull down on positioning cylinders lever (33) until bottom beam (4) rests on the ground.
q.
At front and rear, briefly pull down on two lift cylinder levers (22) and then briefly pull down on positioning
cylinders lever (33). Repeat as required until top hooks (34) are clear of comer blocks (35) at top of shelter (21).
2-58
