TM9-2330-390-14&P2-9.ATTACHING FRONT AND REAR DOLLIES TO SHELTER (Con’t).While In maneuvering position, DO NOT operate positioning cylinders lever. Failure tofollow this warning may cause bottom beam to lower to the ground, causing seriousInjury to personnel.NOTETo ensure access Into shelter through its door, rear dolly must be attached to door endof shelter.d.Move each dolly half into position at ends of shelter (6). Bottom beam (5) should be approximately 6 in.(15 cm) from shelter and alined with sides of shelter.e.Remove each dolly half from maneuvering position (see paragraph 2-21 c).NOTEIf operating on uneven terrain, refer to paragraph 2-32 for Instructions on unlockingthe axle-to-pivot axle bracket coupling.f.Remove eight twist locks (13) from toolbox (7). At front and rear, loosely install two twist locks to bottombeams (5).g.At front and rear, operate two lift cylinder levers (1) and positioning cylinders lever (8) to extend and/orretract lift and positioning cylinders as required to engage two top hooks (4) into comer blocks (9) at top of shelter (6).h.At front and rear, push up on positioning cylinders lever (8) to raise bottom beam (5) 1-2 in. (3-5 cm) offthe ground.i.At front and rear, push up on two lift cylinder levers (1) to draw bottom beam (5) to within approximately2 in. (5 cm) of shelter (6).2-60
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business