TM 9-2330-379-14&P
FRONT DOLLY- CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
NOTE
The following procedures assume the front
dolly major components (front adapter,
connecting link, two upper arm assemblies
and two lower arm assemblies) have been
removed.
8
Lower arm
Bonded joint
Install on bonded joint (12), on center
assemblies
(12), center
spacer (13) and two end bushings (14) at
(3)
spacer (13),
each pivot tube on each lower arm
and two end
assemblies (3).
bushings (14)
9
Front dolly
WARNING
Ensure that all front dolly components to
be moved or assembled are completely
supported/suspended and that adequate
manpower is available to move components.
10
Adapter (1), two
a.
Place upper arm assemblies (2) and
upper arm assem-
lower arm assemblies (3) in proper
blies (2), two
position near adapter (1) and
lower arm assem-
remainder of dolly set.
blies (3), and
connecting link
b.
Place connecting link (4) in position
(4)
on upper and lower arm assemblies.
11 Adapter (1)
Lower arm assem-
Insert pin (9) through lugs at bottom of
blies (3), upper
adapter (1), center pivot tube of lower
arm assemblies
arm assembly (3), upper arm assembly (2)
(2), connecting
and connecting link (4) and secure with
link (4), pin
bolt (10) and nut (11).
(9), bolt (10),
and nut (11)
12
Lower arm assem-
Insert pin (6) through lugs at bottom of
bly (3), pin (6),
front adapter (1) and outside pivot tube
bolt (7), and nut
of lower arm assembly (3). Secure with
(8)
bolt (7) and nut (8).
5-6
