TM 9-2330-379-14&P
REAR DOLLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
3
Lower arm
a.
Remove nut (11) and bolt (10) that
assembly (4)
secure pin (9) attaching lower arm
upper arm
assembly (4), upper arm assembly (3)
assembly (3),
and platform (2) to rear adapter
platform (2),
(1).
pin (9), bolt
b.
Perform same procedure on other side
(10), and nut
of rear dolly.
(11)
4
Lower arm
Bonded joint
Remove two end bushings (14), center
assemblies
(12), center
spacer (13), and bonded joint (12) from
(4)
spacer (13), and
each pivot tube on each lower arm
two end bushings
assembly (4).
(14)
ASSEMBLY
NOTE
The following procedures assume the rear
dolly major components (front adapter,
platform, two upper arm assemblies and two
lower arm assemblies) have been removed.
5
Rear dolly
WARNING
Ensure that all rear dolly components to be
moved or assembled are completely
supported/suspended and that adequate
manpower is available to move components.
6
Adapter (1), two
a.
Place upper arm assemblies (3) and
upper arm assem-
lower arm assemblies (4) in proper
blies (3), two
position near adapter (1) and
lower arm assem-
remainder of dolly set.
blies (4), and
platform (2)
7
Lower arm
Bonded joint (12),
Place bonded joint (12), center spacer
assemblies
center spacer
(13), and two end bushings (14) into each
(4)
(13), and two end
pivot tube on each lower arm assembly
bushings (14)
(4).
5-11
