TM 9-2330-379-14&P
STEERING KNUCKLE ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
BUSHING INSTALLATION
2
Knuckle (1)
Two bushings (2)
Install bushings using an arbor press and
bushing driver fixture.
Be sure that holes in bushings are
aligned with holes in knuckle where the
grease fittings go.
NOTE
The bushings (2) supplied are somewhat
smaller than the kingpin (4). After step 3,
the bushings must be reamed and fitted to the
kingpin (3). After fitting the bushings (2)
to the kingpin (3) all parts must not be
interchanged but rather supplied to organi-
zational maintenance as a matched set for
installation on the dolly set.
3
Two bushings (2)
Using a reamer, fit bushings (2) to
and kingpin (3)
kingpin (3).
The kingpin (3) should slide freely
into the bushings with no noticeable
looseness from side to side.
TASK ENDS HERE
5-16
